more rear end and mock up pictures
Pinion support install and torque
The finished housing. Ready for powder coating. We love adjustment holes!
a nice .008 backlash, as prescribed by Richmond, gave a perfect pattern
The profile milled flanges, with the huge holes for the 5/8 studs.
After the rear was built, the anti-roll bar was fabricated, and installed. This is a very important piece in the rear suspension, as it controls chassis twist, by limiting rear end movement, up and down, from side to side. Look for the links on the back of the suspension brackets, on the rear housing. The wheelie bars were then mocked up and tack welded. Also note the wishbone locator on the top of the rear...out of the way. I have built them above and below... trust me, put it on top.
mocking up the motor, for mount and driveline adjustments.
Checking driveline angle. A nice 2*.
more mock up work